Puzzled by bike materials? Worried about getting wet? Daunted by traffic? Here are the answers to some of the most common questions asked by new cyclists...
Isn’t it dangerous?
It might surprise you to hear that cycling’s not especially dangerous. What about all those stories of cyclists getting killed that you see on the news? Thing is, news is about rare events. Cyclist deaths are rare, so they make the news. The far higher number of pedestrian and motor vehicle deaths don’t.
Cycling is statistically safe. “Per year, there are 10 to 15 fatalities due to people falling off bikes with no other vehicle involved,” says safety expert and co-author of Health on the Move, Malcolm Wardlaw. ‘Around 200 under-65s each year die in falls while walking. I don’t remember the last time I read a newspaper report of a pedestrian killed falling down steps, yet far rarer cases of cyclists killed in falls get a lot of media coverage – together with whether the cyclist was wearing a helmet or not.”
Even when you throw motor vehicles into the mix, cycling remains stubbornly safe. It’s a little more risky than driving in the UK, taken as an average, but not much. The vast number of very safe motorway miles covered by British drivers skews the stats in the car’s favour too. And it’s not like UK cycle commuters are constantly running the gauntlet compared with their counterparts in the Netherlands. “Minority status generates fear,” says Wardlaw.
John Franklin, cycling skills expert and author of Cyclecraft, agrees that the perception of cycling risk doesn’t match the reality. “There’s nothing in life that’s risk free,” he says. “It’s about the management of risk, not simply the fear of risk. As a cycle commuter, managing risk means being assertive, and behaving like trafﬁc so that others will treat you as trafﬁc.”
Don’t you get punctures?
Just like getting soaked, a puncture is a rare event that’s nevertheless very annoying. The best prevention is to use puncture-resistant tyres. These have layers under the tread that prevent bits of glass and the like from getting through to the inner tube. The best puncture-proof tyres, such as the highly-rated Schwalbe Marathon Plus practically eliminate punctures.
You can also protect yourself by simply looking where you’re going. Ride round patches of broken glass, not through them, and avoid sharp-edged potholes that can cause a puncture by pinching the tube between tyre and rim. Fair-weather riders will ﬁnd they get hardly any punctures anyway.
Dry rubber is fairly tough stuff. It takes water on the road to act like a cutting lubricant and help a shard of glass get through the tyre. It’s not that punctures are more inconvenient and annoying when it’s raining, they’re also more likely!
Learning how to fix a 'flat' is an essential skill for all cyclists
How do all these gears work? And why are there so many?
Bikes have gears for the same reason cars do: to let the engine work at a comfortable and efﬁcient speed. But a car’s engine works well at a wide range of speeds, while your bike’s human engine is best in a fairly narrow band of pedalling rates. Bikes therefore need a wide range of gears to cope with hills, and they need to be fairly close to each other.
Most bikes use external gear mechanisms, known as ‘derailleurs’, to move the chain around different sized toothed wheels, called ‘sprockets’ on the wheel and ‘chainwheels’ at the pedal end. The smaller the chainwheel or the larger the rear sprocket, the lower and easier the gear.
In theory, you can ﬂip between sprockets and chainrings to move to the next easiest or hardest gear, but in practice, most people stay in one chainring till they run out of gears, then shift to make life easier or harder.
A less common type of gear system hides the mechanism inside the rear hub. Unsurprisingly called ‘hub gears’ these are eminently practical and tidy, but don’t have quite the wide range of ratios provided by derailleurs.
Many beginning riders ﬁnd the gears the most daunting feature of their bikes. Get yourself to a ﬂat, quiet place like a car park or bike path and shift up and down through the gears until you're completely conﬁdent with how they work and what they do.
What are the different types of brake all about?
You’ve got to be able to stop quickly and in control. Quickly is no problem. The brakes on modern bikes are powerful enough that your ability to brake is limited by the laws of physics; brake too hard and you’ll go over the bars. What you want is ﬁne control over how hard you brake, and consistency is wet and dry conditions.
Brakes either act on the rim of the wheel or a special braking disc near the hub. Rim brakes are simple, but affected by water and damage to the rim, which disk brakes are more complex, but more consistent.
Drop-handlebar road bikes almost always have lightweight rim brakes, because bike for racing are designed to be as light as possible, while mountain bikes use disks for their better overall stopping power.
A typical rim brake, as found on most road bikes
A disc brake, designed to offer the more powerful stopping needed by off-road riders
Why do some bikes have drop bars and some flat?
Drop handlebars were developed for road racing, and work brilliantly if you want to get into a position on the bike that lets you cover a lot of ground quickly. In fact they offer at least three hand positions, so you can move around if you get tired of one stance. But many riders like the more upright position of a ﬂat handlebar, especially for more leisurely riding – where you can sit up and admire the view – or in trafﬁc.
Wider ﬂat bars give better control on rough surfaces, which is why they're the universal choice of mountain bikers, but for riding on the road it’s worth trying both. Drop bars may look less comfortable, but for sportier riding the position can be more comfortable. After all, Tour de France cyclists spend five or six hours a day on drop-bar bikes. They couldn’t do that if the position were inherently uncomfortable, could they?
How high should my saddle be?
Many beginners want to be able to put a foot ﬂat on the ground while sitting in the saddle. The problem is that puts your saddle too low for comfortable, efﬁcient pedalling. With your saddle too low, you’ll get tired quicker. You should have your saddle high enough that your knee is at a 25- to 35-degree angle when your foot is at the bottom of the pedal’s rotation.
You can use a device called a goniometer to measure this, or eyeball it – it will look like the knee is not quite fully straight. On most bikes you’ll still be able to reach the ground from the saddle in this position; you may have to shufﬂe sideways a little.
What are clipless pedals?
Pedals come in three varieties: ﬂat, clip-and-strap and clipless. Flat pedals are found on many bikes and are the simplest type. They have a ﬂat area on either side where you place your feet. High-tech versions come with squared-off steel studs screwed into the body that help soft-soled shoes grip them.
Clip-and-strap pedals have a metal or plastic cage that wraps round the front of your foot to hold it in the right place on the pedal, combined with a leather or plastic strap to keep it in place. They’re now fairly uncommon, but were once the dominant way riders kept their feet on the pedals.
Clipless pedals have almost entirely replaced clip-and-strap pedals for serious cycling. They comprise a cleat on the shoe that fastens into a pedal that has a mechanism rather like a ski binding. Clipless pedals for mountain biking have small cleats that sit in a recess in the sole so the rider can still walk in the shoes. Road clipless systems have larger, external cleats and are inconvenient to walk in. Many recreational and commuter cyclists therefore use mountain bike shoes and pedals even though they never go off road.
In general, clipless pedals are used by performance-orientated riders who like the feeling of being connected to the bike and the greater pedalling efﬁciency of the stiff-soled cycling shoes that accompany them. Flats are favoured by riders who want to be able to ride in regular shoes, or who don’t want to risk being mechanically attached to the bike.
Clipless pedals are popular among road cyclists and mountain bikers for the secure attachment to the pedals they provide
Do I need suspension?
Only if you plan to ride off-road. Good suspension is a boon for proper mountain biking, but if your ambitions don’t involve zooming down Welsh hillsides, you’ll probably be ﬁne with an unsuspended bike. Even if you are planning on heading off-road, many of the suspension forks found on mountain bikes under £500 are quite poor quality; a bike with a rigid fork and higher quality components will often be a better deal.
That saddle looks uncomfortable...
Bike saddles need to be fairly narrow so you can pedal easily. As a result, they undeniably take some getting used to. It’s a bit like getting used to a new pair of shoes; they might pinch in a couple of spots at ﬁrst, but as long as they’re fairly good quality, you'll adapt.
The trick to getting used to a bike saddle is to build up gradually. Go for a ride one day, take a couple days off, then go for another ride. Take another day off, then ride again. Build up both frequency and distance gradually and if at all possible, wear padded bike shorts with no underwear (wash them after every ride).
Very wide and thickly padded saddles are counter-productive. Wide saddles get in the way of comfortable pedalling and thick padding tends to bunch and pinch.
Will I get fit?
In short, yes. Experts recommend at least 20 minutes of aerobic exercise (such as riding a bike hard enough that you get a little out of breath) at least three times per week to maintain basic ﬁtness and health. How much ﬁtter you get than that will depend on how much cycling you do. It’s surprisingly easy to build your ﬁtness up gradually and realise that you’re suddenly capable of riding for miles and miles.
If you’ve been very sedentary and are perhaps a bit overweight, then it’s sensible to check with your doctor before you start riding. Assuming you get the okay – as you almost certainly will – then start with short, ﬂat rides and build up gradually. And if you need inspiration, take a look at the amazing Gary Brennan, who's lost over 20 stone through cycling.
However, ﬁtness is quite speciﬁc to activity. Being ﬁt for riding a bike won’t help you run a marathon (and vice versa) but it’ll probably stop you getting out of breath running for a bus.
If I get fit, won’t my legs get huge?
Some female riders worry about this, but it’s very unlikely. Look at top British cyclist Victoria Pendleton. Even though she’s one of the fastest female riders in the world, Pendleton’s shapely legs have made her a favourite of Sunday supplements and men’s mags.
Cycling is far more likely to build lean, toned leg muscles than huge bulging thighs because most of the time the effort you put out is far less than the bulk-building efforts of bodybuilders. So, ladies, you needn’t worry.
British track star Victoria Pendleton proves that you don’t have to be muscly to be Olympic-standard quick on a bike
Won’t I get wet if I live in the UK?
Probably not. The Met Ofﬁce says there was no signiﬁcant rain in 2010 at commuting times for 95 percent of mornings and evenings in most major UK cities. If that doesn’t gel with your idea that we live in a rather soggy country, that’s because rain tends to leave things wet for a while. Barry Gromett of the Met Ofﬁce points out that for many riders it may even be better than this. “October to November is one of the wetter times of the year and many people may elect to forego the bike during the winter months,” he says.
This article was originally published in On Your Bike: Your Complete Beginner's Guide to Cycling, available at all good newsagents. You can also order it online by following this link.