MTB Workshop & Tech Forum

Front mech wear?

 
View previous topic :: View next topic  
Post new topic   Reply to topic    BikeRadar Forum Index > Mountain bike > MTB Workshop & Tech
Author Message
Stu 74
Been having a few problems setting up my front mech (in particular shifting down from middle to granny). Was checking it out and there seems to be an awful lot of play in it but not sure if it has always been like this.

It is a Shimano FD M510 that has done about 1000Km.

I'm guessing that the pivots in the mech have worn. Is it normal for front mechs to wear like this?

Cheers

Stu

Send private message
supersonicLives Here
Usually they stiffen up! But wear and sloppy cages can cause rattle and rub.

Zaskar LE 1996
Zaskar Carbon Team
MYSPACE
Send private message
Stu 74
Thanks, think I will order a replacement. If it has the same amount of play I can always send it back Smile

Stu

Send private message
nicklouseLives Here
problems going down to the small cog are normally cable related.

"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools Question SheldonBrown
Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    BikeRadar Forum Index > Mountain bike > MTB Workshop & Tech All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
BikeRadar topic RSS feed 



Powered by phpBB © 2001, 2005 phpBB Group