BB Question

Home of daft questions and helpful answers.
User avatar
rubertoe
Posts: 3965
Joined: Thu Jun 02, 2011 17:14 pm

BB Question

Postby rubertoe » Mon Nov 19, 2012 08:22 am

my FSA megaexo is on its way out as it has a bit of play in it,

My question is relativly simple, can I swap this for any external BB or do i need another Megaexo?

I currently use a FSA Gossamer Pro chainset and was thinking of going for a cheaper BB providing it will fit.

Any recomendations for a replacement BB?
"If you always do what you've always done, you'll always get what you've always got."

PX Kaffenback 2 = Work Horse
B-Twin Alur 700 = Sundays and Hills

User avatar
supersonic
Lives Here
Posts: 81829
Joined: Fri Nov 25, 2005 11:50 am

Re: BB Question

Postby supersonic » Mon Nov 19, 2012 17:59 pm

Shimano work fine with them.

User avatar
nicklouse
Lives Here
Posts: 80713
Joined: Thu Mar 20, 2003 12:14 pm

Re: BB Question

Postby nicklouse » Mon Nov 19, 2012 18:26 pm

with FSA nothing is simple. it depends on what version of the FSA bb is there.
"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown

User avatar
MTB-Idle
Posts: 1263
Joined: Thu Oct 01, 2009 19:05 pm
Contact:

Re: BB Question

Postby MTB-Idle » Mon Nov 19, 2012 22:33 pm

yup, check carefully. I have two worn mega exo cranks in my spares box and rather unhelpfully they each have different axle sizes (and therefore need different BB's).

Here's the Mega Exo Gossamer crankset. Note the diameter of the axle, it's largish (the same as Shimano 105)

Image

and here's the Mega Exo Omega crankset. Again, note the diameter of the axle. It's much smaller than the other one :x

Image

Switch the whole thing to Shimano 105, much easier.
FCN = 4

centimani
Posts: 466
Joined: Mon May 30, 2011 20:11 pm

Re: BB Question

Postby centimani » Wed Nov 21, 2012 21:58 pm

Before you go spending too much money (unless you fancy an upgrade anyway)..assuming the basic construction of their BBs is the same across the range, the plastic endcap of the BB itself is a tophat section. It wears away, allowing that sloppiness. Its a bit hard to explain, but certainly on the Omega, the cranks are running on the plastic of that tophat washer... not the bearing itself.
You can buy them for a few quid each (sorry, can't remember where i got mine).
If the cranks spin graunchily, then the bearings probably had it anyway
Image


Return to “The Workshop.”

Who is online

Users browsing this forum: No registered users and 1 guest