Fitting a groupset question

Sorting out your thrunge brackets, fettling your inter-rositers and even stuff about bike parts.
nick_1978
Posts: 27
Joined: Sun Mar 25, 2012 16:25 pm

Fitting a groupset question

Postby nick_1978 » Wed Nov 21, 2012 16:29 pm

Hi,

I'm after some advice, I have a frame that I'd like to fit a Shimano SLX or Deore groupset to.
However, I'm a bit confused as to what I actually need to get with regards to the chain line...
If I put a Shimano 9 speed cassette on the rear, what bottom bracket size do I need?

I am assuming my rear dropout width is 135mm, I'm pretty sure it is but I'll check.
If I put a Shimano triple chainset on the front, what length BB do I need, or will they be a standard size?

Also, do I need a specific 9 speed shadow cassette & chain for the SLX Shadow rear mech?

Thanks in advance!

User avatar
benpinnick
Posts: 4137
Joined: Sun Sep 16, 2007 17:08 pm

Re: Fitting a groupset question

Postby benpinnick » Wed Nov 21, 2012 16:36 pm

If its a new SLX set, no need to worry on BB. All one size fits all now. As for cassette and chain, any will do as long as its nine speed (SRAM or Shimano, or KMC chain). However it will be cheaper to buy a full groupo than mix and match.
A Flock of Birds
+ some other bikes.

User avatar
nicklouse
Lives Here
Posts: 80713
Joined: Thu Mar 20, 2003 12:14 pm

Re: Fitting a groupset question

Postby nicklouse » Wed Nov 21, 2012 16:36 pm

it all depends on the cranks.

if HT2 just buy then. get the BB shell faced if it has not been done. and then fit as per the instructions.

and nope as long as it is the correct speed for the shifters and shimano it will be fine.

have a read of Parktools.
"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown

mister p
Posts: 405
Joined: Thu Dec 21, 2006 13:36 pm
Contact:

Re: Fitting a groupset question

Postby mister p » Wed Nov 21, 2012 16:39 pm

If you buy a current SLX or Deore chainset then there aren't different bottom bracket axle lengths. The cranks are Hollowtech II so the axle is part of the crank and you use spacers to match it to your frame.

EDIT - too slow, twice!


Return to “MTB Workshop & Tech”

Who is online

Users browsing this forum: JGTR and 2 guests