Bikeradar gallery

Interbike bikes: Titus, Jamis and Van Dessel

The FTM seat post and seat tube grow in diameter relative the Motolite, which will continue in the lineup as a lower-end model.

  • The iconic Titus Racer-X has been replaced by a lighter and more modern frame simply called X.
  • The curved tubes allow much more fork crown clearance than before.
  • The shock mount is machined from an extruded chunk of aluminium.
  • The Racer-X will continue on but is now substantially less expensive at US$1,695.
  • The Racer-X Carbon now becomes the X Carbon and drops some 300g in the process.
  • An all-new rear end shaves 175g on its own.
  • Asymmetrical hydroformed chain stays grace the rear end of the X Carbon.
  • The new bottom bracket and main pivot mount is now a carbon unit with aluminium inserts instead of the old version's heavy cast aluminium bit.
  • A one-piece carbon link replaces the previous three-piece link.
  • The seat stay bridge has now moved ahead of the seat tube for more tire clearance.
  • The X Carbon wears an integrated head tube that is apparently stiffer than the old one while also offering a cleaner look.
  • The FTM replaces the Motolite in the Titus lineup.
  • Like on the X, the FTM wears an all-new rear end.
  • A one-piece carbon link is used here as well.
  • The curved tubes on the FTM add fork crown clearance and also lend a more modern look.
  • The FTM seat post and seat tube grow in diameter relative the Motolite, which will continue in the lineup as a lower-end model.
  • The FTM shock mount is milled from extruded aluminium.
  • The aluminium El Guapo drops 150g from last year.
  • aluminium El Guapos now all use 1.5
  • ISCG05 tabs have been added to the El Guapo for 2009.
  • The burly aluminium link still uses two mounting positions to alter the linkage rate depending on if you're using an air or coil shock.
  • New for 2009 is the Fireline Steel Exo hardtail.
  • The Ligero is gone but the Solera gets upgraded with an Isogrid top tube.
  • The Exogrid-tubed Vuelo carries on for 2009.
  • The Jamis Xenith SL now uses a tapered steerer tube and a BB30 bottom bracket.
  • The tapered fork is stiffer and better handling yet gains no weight thanks to its fully hollow construction.
  • A BB30 bottom bracket beefs up the drivetrain and also reduces weight.
  • Jamis has swapped from Easton to 3T on the Xenith and the SL even uses a traditional bend handlebar.
  • The Xenith T is mostly unchanged...
  • ...though the trailing edges have been rounded throughout for better aerodynamic performance in crosswinds.
  • The value-oriented Trilogy gains from the lessons learned on the Xenith T…
  • …such as the Windshield fork and brake setup.
  • The Supernova is ready to hit the 'cross circuit with its lightweight aluminium frame and discipline-specific top tube shaping.
  • The flattened part of the top tube is moved closer towards the middle where it's actually used.
  • Lighter dropouts now sprout fender mounts.
  • As is now becoming standard practice, Jamis showed off a show special version, in this case based on the Supernova.
  • Zipp carbon tubulars and TRP EuroX Magnesium brakes dump heaps of weight.
  • The Selle San Marco Superleggera saddle on the Jamis show special is undoubtedly light but we're not sure we'd like to jump on it during a 'cross race.
  • The Jamis Sonik track bike is stiffer and quicker for 2009.
  • The hydroformed seat tube allows the wheel to tuck in tighter.
  • Steel-lined horizontal dropouts and an American Classic 420 Track wheelset round things out.
  • Now this is good thinking: replaceable barrel nuts offer some cheap insurance in case the seat binder is overtightened.
  • Jamis has brought back the Eclipse to mark its 20th anniversary. The Eclipse returns to an all-steel configuration using Reynolds 853 tubes.
  • The Dakar XCR racer gets upgraded pivot hardware for better suspension tracking.
  • An all-new Dakar XCT offers near-XCR weight but will more capable suspension and handling for trail bike duty.
  • The Dakar XCT main frame uses swoopy tubes.
  • Jamis equips the Dakar XCT with its familiar mp3 rear suspension system.
  • The longer-travel XAM receives upgraded pivot hardware as well and will come stock with Truvativ's new HammerSchmidt system.
  • The Jamis XAM offers plenty of beef for heavy-duty trail use.
  • A stout aluminium link keeps things tracking true.
  • Van Dessel's Gin & Trombones is so popular that it's nearly sold out already.
  • This year's Gin & Trombones gets upgraded to a tapered 1 1/8
  • Bigger and/or stronger 'cross riders might opt for the all-aluminium Hole Shot.
  • The Rivet road racer gets a tapered front end and BB30 bottom bracket.
  • The bigger lower fork diameter makes for better braking and more precise handling.
  • The BB30 bottom bracket is an optional upgrade.
  • The Rivet is just 1050g and is reasonably priced, too.
  • Milled-out aluminium dropouts retain durability while shaving a few precious grams.
  • The all-aluminum Hellafaster is apparently Van Dessel's go-to frame for riders who want über-stiffness.
  • An aero post is fixed to the frame…

Showing 16 of 67

The FTM seat post and seat tube grow in diameter relative the Motolite, which will continue in the lineup as a lower-end model.

© James Huang